This 2 post floor plate lift is essential for the workshop with roof height challenges. Strong 4 tonne lift fully certified and easy to assemble. 4 Ton 2-Post Floor-plate hoist is a hoist with dual chain over hydraulic cylinder drive, stable lifting and lowering. It incorporates two steel cables for equalisation, forcing the two carriages to move synchronously.
ü Manual single side release system
ü 5 years warranty on steel and full 12mth warranty on other components
ü Dual hydraulic cylinder drive, stable lifting and lowering
ü Rubber door protection prevents unexpected damage to the vehicle
ü Two steel cable equalisation forces the two carriages to move synchronously
ü Reversed hand pump joint on hydraulic block for emergency lowering
ü Proven by dynamic testing to 125% of rated capacity and static testing to 150%
ü CE Certified
- Capacity 4 tonne
- Lifting Height 1900mm
- Minimum height 110mm
- Rise Time <50secs
- Drop Time <20secs
- Single point manual release
- Power of Motor 2.2kw
- Power Supply 220v
- Width of Rack 3499mm
- Height of Rack 2824mm
- Width between Pillars 2880mm
- Net Weight 592mm
FINANCE AVAILABLE AT VERY COMPETITIVE RATES
PURCHASE BEFORE JUNE 30TH FOR A TOTAL TAX DEDUCTION
These lifts meet the Australian Standard AS/NZ 1418.9:1996 and AS/NZS 2550.9:1996,
Hoist Equipment Specifications
The height from floor that this device can lift to. Otherwise known as maximum clearance.
The time it takes for this device to lift from floor to maximum height. Measured in seconds.
The time it takes for this devixe to lower from Maximum Height to floor height. Measured in seconds.
Specifies whether Single or Three Phase power is required for this device. Some items are available for both Single and Three Phase.